Wiper Signal Circuit

CRUISE CONTROL: DYNAMIC LASER CRUISE CONTROL SYSTEM: Wiper Signal Circuit
- Wiper Signal Circuit

DESCRIPTION

When the distance control ECU detects that the wipers are operating, the dynamic laser cruise control system will be canceled.

HINT
A wiper switch signal is sent to the distance control ECU via the CAN and BEAN. If there are any malfunctions in this circuit, check for DTCs in the CAN communication and multiplex communication systems. When the wiper is in the HI or LO mode, the dynamic laser cruise control is automatically canceled and goes into the standby mode.

INSPECTION PROCEDURE

PROCEDURE

1. INSPECT WIPER AND WASHER SYSTEM

OK:

Wiper function is normal.

NG -- GO TO WIPER AND WASHER SYSTEM

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE