Canada - Body - Moonroof Initialization Procedure

Bulletin
3227

Issue Date
August 11, 2009

Market
Canada

Title:
INITIALIZATION OF MOON ROOF DURING PDS

Component
GENERAL INFORMATION

Models
'10 Avalon

INTRODUCTION:
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the moon roof will be inoperative due to loss of the moon roof position memory stored in the microcomputer.

Initialize the moon roof after installing the Short Pin in its original location during Pre-Delivery Service (PDS).

NOTE
Any time the battery terminal has been disconnected, the sliding roof MUST be re-initialized.







APPLICABILITY:







WARRANTY INFORMATION:


INITIALIZATION PROCEDURE:
1. Cycle the ignition switch to the "IG-ON" position.

NOTE
Make sure the sliding roof is closed.







2. Push and hold the "TILT UP" side of the switch until the moon roof tilts all the way up and then tilts down slightly. Fully close moon roof to continue.
3. Check for proper operation of the "One-touch slide open and close" and "One-touch tilt up and down" functions by pushing the switch briefly to the "slide open" and "tilt open" positions.

NOTE
Jam protection function becomes effective through the above initialization procedure.