Body - Moonroof Initialization Procedure

T-SB-0223-09

July 27, 2009

Initialization of Moon Roof During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

Introduction

As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the moon roof will be inoperative due to loss of the moon roof position memory stored in the microcomputer.

Initialize the moon roof after installing the Short Pin in its original location during Pre-Delivery Service (PDS).

NOTE

Any time the battery terminal has been disconnected, the moon roof MUST be re-initialized.





Warranty Information

Initialization Procedure

1. Cycle the ignition switch to the "IG-ON" position.

NOTE

Make sure the moon roof is closed.





2. Push and hold the "TILT UP" side of the switch until the moon roof tilts all the way up and then tilts down slightly. Fully close moon roof to continue.

3. Check for proper operation of the "One-touch slide open and close" and "One-touch tilt up and down" functions by pushing the switch briefly to the "slide open" and "tilt open" positions.

NOTE

Jam protection function becomes effective through the above initialization procedure.