Installation

WINDSHIELD / WINDOWGLASS: QUARTER WINDOW GLASS (for Coupe):

COMPONENTS







INSTALLATION

1. INSTALL QUARTER WINDOW ASSEMBLY LH





(a) Using a brush, apply Primer M to the exposed part of the vehicle body.

- Allow the Primer M to dry for 3 minutes or more.
- Do not apply Primer M to the adhesive.
- Throw away any leftover Primer M.
- Do not apply too much Primer M.

(b) Using a brush or sponge, apply Primer G to the contact surface of the quarter window glass.





HINT: If Primer G is applied to an area other than that which is specified, wipe off the primer with white gasoline before it dries.

NOTICE:
- Allow the Primer G to dry for 3 minutes or more.
- Throw away any leftover Primer G.
- Do not apply too much Primer G.

(c) Apply adhesive to the quarter window glass.
Adhesive:
Part No. 08850-00801 or equivalent
(1) Cut off the tip of the cartridge nozzle.

HINT: After cutting off the tip, use all adhesive within the time written in the table below.

Usage timeframe:





(2) Load the sealer gun with the cartridge.
(3) Apply adhesive to the quarter window glass as shown in the illustration.





Specification:





(d) Install the quarter window glass to the vehicle body.
(1) Lightly press the front surface of the quarter window glass to ensure that the quarter window glass is securely fit to the vehicle body.

NOTICE:
- Check that the clips are attached to the vehicle body correctly.
- Check that the vehicle body and quarter window glass have a small gap between them.

(2) Hold the quarter window glass in place securely with protective tape or equivalent until the adhesive hardens.

NOTE: Do not drive the vehicle for the amount of time written in the table below.

Minimum time:





2. CHECK FOR LEAKS AND REPAIR
(a) Conduct a leak test after the adhesive has completely hardened.
(b) Seal any leaks with auto glass sealer.