Body - Moonroof Initialization Procedure

PRE-DELIVERY SERVICE
PD043-07

Title:
INITIALIZATION OF MOON ROOF
DURING PDS

Models:
'08 Solara

June 8, 2007

Introduction

The moon roof on 2008 model year Solara vehicles must be initialized after installing the DCC fuse during Pre-Delivery Service (PDS).

The installation of the DCC fuse, and the initialization procedure shown below, will enable the operation of the "one-touch slide open and close" "one-touch tilt up and down," and "jam protection" functions of the sliding roof.

NOTE:
Any time the battery terminal has been disconnected, the moon roof MUST be re-initialized.

Applicable Vehicles

^ 2008 model year Solara vehicles.

Initialization Procedure





1. Turn the ignition switch to the ~ON" position.

2. Push and hold the moon roof switch to the "TILT UP" side until the moon roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.4 in.]) at the rear.

3. Check for proper operation of the "one-touch slide open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "SLIDE OPEN" and "TILT UP" positions.

NOTE:
Jam protection function becomes effective through the above initialization procedure.





Warranty Information