Installation

E351 MANUAL TRANSAXLE: FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT:

INSTALLATION

1. INSTALL FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT
(a) Thread the select cable through the floor hole and retainer.
(b) Connect the select cable to the grommet.





(c) Install the retainer to the grommet.

NOTE: Fit the 3 projections of the grommet into the 3 holes of the retainer.

(d) Install the 2 retainer set bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)





(e) Connect the select cable to the shift lever retainer.

- The projecting part of the cable outer should face upward when the select cable is connected.
- After installation, make sure that the cable outer lock is projecting from A as shown in the illustration.





(f) Connect the top end of the select cable to the shift lever assembly and install the clip.

- The serrated part of the select cable point should face upward when the select cable point is connected.
- The clip should be installed in the direction as shown in the illustration.

(g) Connect the select cable to the control cable bracket and install a new clip.
(h) Connect the select cable to the transaxle and install the washer and clip.
2. INSTALL AIR BAG SENSOR ASSEMBLY CENTER

HINT: (Installation)

3. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY

HINT: (Installation)

4. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY W/PASSENGER AIR BAG ASSEMBLY

HINT: (Installation)