Disassembly

E351 MANUAL TRANSAXLE: SHIFT AND SELECT LEVER SHAFT:

DISASSEMBLY

1. REMOVE CONTROL SHIFT LEVER BUSH





(a) Remove the control shift lever bush from the selecting bellcrank No.2.
2. REMOVE SELECTING BELLCRANK DUST COVER NO.1





(a) Remove the selecting bellcrank dust cover No.1 from the selecting bellcrank No.2.
3. REMOVE SELECTING BELLCRANK SUPPORT SUB-ASSEMBLY





(a) Remove the nut, wave washer and selecting bellcrank No.2 plate washer from the selecting bellcrank No.2.





(b) Remove the selecting bellcrank support sub-assembly from the selecting bellcrank No.2.
4. REMOVE SELECTING BELLCRANK DUST COVER NO.2





(a) Remove the selecting bellcrank dust cover No.2 from the selecting bellcrank No.2.
5. REMOVE SELECTING BELLCRANK NO.2 BUSH





(a) Remove the 2 selecting bellcrank bushes from the selecting bellcrank No.2.
6. REMOVE SHIFT LEVER INNER NO.2





(a) Hold the shift and select lever in a vise with soft jaws.

NOTE: Do not damage the shift & select lever shaft.

(b) Using a pin punch (dia5 mm), remove the shift inner lever slotted pin and the transmission oil baffle.

NOTE: Do not damage the shift & select lever shaft.

(c) Apply force to the select return compression spring No.1 and select return compression spring No.2 then hold it in a vise with soft jaws.





(d) Using 2 screwdrivers and a hammer, remove the select spring No.2 seat snap ring from the shift & select lever shaft.

NOTE: Do not damage the shift & select lever shaft.

7. REMOVE SELECT SPRING SEAT NO.1





(a) Using a pin punch (dia5 mm), remove the shift inner lever slotted pin from the shift & select lever shaft.





(b) Remove the shift lever assembly select return compression spring No.1 and select spring seat No.1 from the shift & select lever shaft.
8. REMOVE SHIFT INTER LOCK PLATE COVER





(a) Remove the shift inter lock plate cover from the shift inter lock plate.
9. REMOVE SHIFT LEVER INNER NO.1





(a) Remove the shift lever inner No.1 from the shift inter lock plate.
10. REMOVE SELECT SPRING NO.1 SEAT SHAFT SNAP RING





(a) Using 2 screwdrivers and a hammer, remove the select spring No.1 seat shaft snap ring.

NOTE: Do not damage the shaft.

11. REMOVE CONTROL SHAFT COVER OIL SEAL





(a) Using a screwdriver, remove the control shaft cover oil seal from the control shaft cover.

HINT: Tape the screwdriver tip before use to avoid damage.