Disassembly

E351 MANUAL TRANSAXLE: OUTPUT SHAFT:

DISASSEMBLY

1. REMOVE 4TH DRIVEN GEAR





(a) Using SST and a press, remove the output shaft rear bearing (inner race) and 4th driven gear.
SST: 09950-00020
2. REMOVE OUTPUT GEAR SPACER





(a) Remove the output gear spacer from the output shaft.
3. REMOVE 2ND GEAR





(a) Using SST and a press, remove the 3rd driven gear and 2nd gear from the output shaft.
SST: 09950-00020
4. REMOVE SYNCHRONIZER RING SET NO.2





(a) Remove the synchronizer ring set No.2 from the transmission clutch hub No.1.
5. REMOVE 2ND GEAR NEEDLE ROLLER BEARING





(a) Remove the 2nd gear needle roller bearing from the output shaft.
6. REMOVE 2ND GEAR BEARING SPACER





(a) Remove the 2nd gear bearing spacer from the output shaft.
7. REMOVE 2ND GEAR BUSH





(a) Remove the 2nd gear bush from the output shaft.
8. REMOVE 2ND GEAR BUSH BALL





(a) Using a magnetic finger, remove the 2nd gear bush ball from the output shaft.
9. REMOVE 1ST GEAR





(a) Using SST and a press, remove the transmission clutch hub No.1 and 1st gear from the output shaft.
SST: 09950-00020
10. REMOVE SYNCHRONIZER RING SET NO.1





(a) Remove the synchronizer ring set No.1 from the 1st gear.
11. REMOVE 1ST GEAR NEEDLE ROLLER BEARING





(a) Remove the 1st gear needle roller bearing from the output shaft.
12. REMOVE OUTPUT SHAFT FRONT BEARING





(a) Using SST and a press, remove the output shaft front bearing (inner race) from the output shaft.
SST: 09950-00020
SST: 09950-60010
09951-00320
SST: 09950-70010
09951-07150

NOTE: Do not overtighten the SST.

13. REMOVE REVERSE GEAR





(a) Remove the transmission clutch hub No.1, 3 synchromesh shifting keys No.1 and 3 synchromesh shifting key springs No.1 from the reverse gear.