Installation

E351 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL:

INSTALLATION

1. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09608-10010
SST: 09950-70010
09951-07200
Drive in depth:
0 ± 0.5 mm (0 ± 0.020 in.)

NOTE: Be careful not to damage the oil seal lip.

2. INSTALL TRANSAXLE CASE OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09608-32010
SST: 09950-70010
09951-07200
Drive in depth:
3.5 ± 0.5 mm (0.138 ± 0.020 in.)

NOTE: Be careful not to damage the oil seal lip.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

HINT: (Installation)

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT: (Installation)

5. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
6. ADD MANUAL TRANSAXLE OIL





(a) Add manual transaxle oil.
Oil grade:
API GL-4 or GL-5
Viscosity:
SAE 75W-90
Capacity:
2.5 liters (2.6 US qts, 2.2 lmp. qts)
7. INSPECT AND ADJUST MANUAL TRANSAXLE OIL LEVEL

HINT: (Testing and Inspection)

8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

9. CHECK ABS SPEED SENSOR SIGNAL

HINT: (Test Mode Procedure)