System Specifications
CHAIN TENSIONER SLIPPERTorque 19 Nm (194 kgf-cm, 14 ft-lbf)
TIMING CHAIN COVER SUB-ASSEMBLY
NOTICE:
- Remove any oil from the contact surface.
- Install the chain cover within 3 minutes after applying seal packing.
- Do not start the engine for at least 2 hours after installing the chain cover.
Install and temporarily tighten the 14 bolts and 2 nuts in several steps.
Install the timing chain cover with the 14 bolts and 2 nuts.
For bolt A - Torque: 55 Nm (561 kgf-cm, 41 ft-lbf)
For bolt B - Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
For bolt C - Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
For nut - Torque: 11 Nm (112 kgf-cm, 8 ft-lbf)
Using an E10 "TORX" socket, install the stud bolt to the drive belt tensioner.
Torque: 22 Nm (220 kgf-cm, 16 ft-lbf)
CRANKSHAFT PULLEY
Using SST, install the pulley bolt.
Torque 180 Nm (1836 kgf-cm, 135 ft-lbf)