Removal

2AZ-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR:

REMOVAL

HINT: A bolt without a torque specification is shown in the standard bolt chart (Standard Bolt - Specified Torque For Standard Bolts).

1. REMOVE ENGINE UNDER COVER RH





(a) Remove the 5 screws, 3 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH





(a) Remove the clip, 2 bolts and apron seal.
3. REMOVE CRANKSHAFT POSITION SENSOR





(a) Disconnect the sensor connector.
(b) Remove the bolt, clamp and sensor.