Installation

C59 MANUAL TRANSAXLE: TRANSMISSION CONTROL CABLE:

COMPONENTS

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the retainer to the grommet.

NOTE: Fit 4 projections of the grommet into 4 holes of the retainer.

(b) Install the control cable assembly with the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)

(d) Connect the shift cable with the 2 clip from the bracket.
(e) Connect the shift cable end of the shift cable with the 2 washer and 2 clip to the transaxle.
2. CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SELECT

(a) Connect the select cable to the shift lever assembly.

- The projecting part of the cable outer should face upward when the shift cable is installed.
- Make sure that after installation the cable outer spring is moved to the place shown in the illustration.

(b) Connect the select cable end with the clip to the shift lever assembly.
(c) Connect the select cable to the clamp.
3. CONNECT FLOOR SHIFT CABLE TRANSMISSION CONTROL SHIFT

(a) Connect the shift cable to the shift lever assembly.

- The projecting part of the cable outer should face upward when the shift cable is installed.
- Make sure that after installation the cable outer spring is moved to the place shown in the illustration.

(b) Connect the shift cable end as shown in the illustration.
(c) Install the washer and clip.
(d) Connect the shift cable to the clamp.
4. INSTALL FRONT FLOOR HEAT INSULATOR NO.1
(a) Install the heat insulator No. 1 with the 3 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
5. INSTALL EXHAUST PIPE ASSEMBLY

HINT: (Installation)

6. INSTALL AIR BAG SENSOR ASSEMBLY CENTER (Installation)

7. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (Installation)

8. INSTALL INSTRUMENT PANEL BOX (Installation)

9. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CTR (Installation)

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
11. CONNECT BATTERY NEGATIVE TERMINAL
12. INSPECT SRS WARNING LIGHT