Counter Shaft

A246E AUTOMATIC TRANSAXLE: COUNTER SHAFT:

INSPECTION

1. INSPECT COUNTER SHAFT ASSEMBLY





(a) Using soft jaws, hold the differential drive pinion by a vise.
(b) Using SST and spring tension gauge, measure the starting torque of the counter shaft assembly.
SST: 09350-32014
09351-32170
Starting torque:
with spring tension gauge
1.2 to 2.0 kg (2.6 to 4.4 lb)
with torque wrench (hexagon nut side)
New bearing - Torque: 0.6 to 1.0 Nm (6 to 10 kgf-cm, 5.2 to 8.7 in-lbf)
Reused bearing - Torque: 0.3 to 0.5 Nm (3 to 5 kgf-cm, 2.6 to 4.3 in-lbf)
If the torque exceeds the limit, replace the spacer.
2. INSPECT UNDERDRIVE PLANETARY SUN GEAR SUB-ASSEMBLY





(a) Using a caliper gauge, measure the bushing inside diameter of the underdrive planetary sun gear sub-assembly as shown in the illustration.
Standard inside diameter:
29.800 to 29.825 mm (1.17323 to 1.17421 in.)
Maximum inside diameter:
29.870 mm (1.17598 in.)
3. INSPECT UNDERDRIVE PLANETARY GEAR ASSEMBLY





(a) Using a feeler gauge, measure the planetary pinion gear thrust clearance.
Standard clearance:
0.2 to 0.5 mm (0.008 to 0.020 in.)
Maximum clearance:
0.5 mm (0.020 in.)
If the clearance is greater than the maximum, replace the underdrive planetary gear assembly.