Reassembly

A246E AUTOMATIC TRANSAXLE: OIL PUMP: REASSEMBLY

REASSEMBLY

1. INSTALL FRONT OIL PUMP DRIVEN GEAR





(a) Make sure the top of the front oil pump driven gear are facing upward.
2. INSTALL FRONT OIL PUMP DRIVE GEAR
(a) Make sure the top of the front oil pump drive gear are facing upward.
3. INSTALL FRONT OIL PUMP OIL SEAL





(a) Using SST and a hammer, install a new front oil pump oil seal. The seal end should be flush with the outer edge of the pump body.
SST: 09350-32014
09351-32140
4. INSTALL STATOR SHAFT ASSEMBLY





(a) Align the bolt holes of the stator shaft assembly with those of the pump body.
(b) Torque the 11 bolts.
Torque: 9.8 Nm (99 kgf-cm, 86 in-lbf)
5. INSTALL STATOR SHAFT CLUTCH DRUM THRUST WASHER





(a) Coat the stator shaft clutch drum thrust washer with petroleum jelly.
(b) Align the tab of the stator shaft clutch drum thrust washer with the hollow of the front oil pump body.
6. INSTALL CLUTCH DRUM OIL SEAL RING





(a) Install the 2 clutch drum oil seal rings to the stator shaft back side.

NOTE: Do not spread the ring ends more than necessary.

HINT: After installing the clutch drum oil seal rings, check that they move smoothly.

7. INSPECT OIL PUMP ASSEMBLY (Oil Pump)