Installation

A246E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL:

COMPONENTS

















INSTALLATION

1. INSTALL TRANSAXLE HOUSING OIL SEAL (for RH Side)





(a) Using SST and a hemmer, drive in a new oil seal.
SST: 09350-32014
09351-32130
09351-32150
Oil seal drive in depth:
1.5 to 2.5 mm (0.059 to 0.098 in.)
(b) Coat the lip of the oil seal with MP grease.
2. INSTALL TRANSAXLE CASE OIL SEAL (for LH Side)





(a) Using SST and a hammer, drive in a new oil seal.
SST: 09350-32014
09351-32111
09351-32130
Oil seal drive in depth:
4.8 to 5.8 mm (0.189 to 0.228 in.)
(b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

HINT: (Installation)

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT: (Installation)

5. INSTALL ENGINE UNDER COVER LH
6. INSTALL ENGINE UNDER COVER RH
7. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
8. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:
T-IV
Capacity:
3.0 liters (3.2 US qts, 2.6 lmp.qts)
9. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT: (Procedures)

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

11. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)

HINT:
- with VSC (Test Mode Procedure)
- without VSC (Test Mode Procedure)