Installation

BRAKE: REAR DISC BRAKE:

COMPONENTS





INSTALLATION

1. INSTALL DISC BRAKE CYLINDER ASSEMBLY REAR LH





(a) Install the disc brake cylinder with the 2 bolts.
Torque: 46.6 Nm (475 kgf-cm, 34 ft-lbf)
(b) Install a new gasket and flexible hose with the union bolt.
Torque: 29 Nm (296 kgf-cm, 21 ft-lbf)

HINT:
- Gasket has 2 types: 2-piece type and 1-piece type.
- Install the flexible hose lock securely in the lock hole in the brake cylinder.

2. INSTALL DISC BRAKE PAD KIT REAR (PAD ONLY)

NOTE: If necessary, replace the anti-squeal shim kit when replacing the brake pad.

(a) Apply disc brake grease to inside of anti-squeal shims, and install the anti-squeal shims on each pad.
(b) Install the inner pad with the pad wear indicator plate facing upward, and install the outer pad.

NOTE: There should be no oil or grease on the friction surface of the pads and the disc.

(c) Install the 2 pad guide pins.





(d) Install the anti-rattle spring No. 1 anti-rattle spring No. 2 and clip.
3. FILL RESERVOIR WITH BRAKE FLUID
4. BLEED MASTER CYLINDER
(a) Bleed the master cylinder (Service and Repair).
SST: 09023-00101
5. BLEED BRAKE LINE
(a) Bleed the brake line (Service and Repair).
6. CHECK FLUID LEVEL IN RESERVOIR
7. INSPECT FOR BRAKE FLUID LEAK
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)