Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Vehicle Stability Control System








BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C0226/21: SFR Solenoid Circuit

DTC C0226/21 - SFR Solenoid Circuit

DTC C0236/22 - SFL Solenoid Circuit

DTC C0246/23 - SRR Solenoid Circuit

DTC C0256/24 - SRL Solenoid Circuit

DTC C1225/25 - SM Solenoid Circuit

DESCRIPTION

This solenoid goes on when signals are received from the ECU and controls the pressure acting on the wheel cylinders to control the braking force.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTE: When replacing the ABS and TRACTION actuator assembly, perform zero point calibration (Programming and Relearning).

PROCEDURE

1. RECONFIRM DTC

HINT: These codes are detected when a problem is determined in the ABS and TRACTION actuator assembly.

The solenoid circuit is in the ABS and TRACTION actuator assembly.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the ABS and TRACTION actuator assembly.

(a) Clear the DTCs (Vehicle Stability Control System).
(b) Turn the ignition switch to the ON position.
(c) Are the same DTCs recorded?
NO -- END
YES -- REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY