Installation

C59 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL TRANSAXLE CASE OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09710-20011
09710-06071
SST: 09950-70010
09951-07200
Drive in depth:
1.6 to 2.2 mm (0.063 to 0.087 in.)

NOTE: Be careful not to damage the oil seal lip.

2. INSTALL TRANSMISSION CASE OIL SEAL





(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST: 09726-36010
SST: 09950-70010
09951-07200
Drive in depth:
9.6 to 10.2 mm (0.378 to 0.402 in.)

NOTE: Be careful not to damage the oil seal lip.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

HINT: (Installation)

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (Installation)

5. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
6. ADD MANUAL TRANSAXLE OIL





(a) Add the manual transaxle oil.
Oil grade:
API GL-4 or GL-5
Viscosity:
SAE 75 W-90
Capacity:
1.9 liters (2.0 US qts, 1.7 lmp. qts)
Torque: 39.2 Nm (400 kgf-cm, 29 ft-lbf)
7. INSPECT AND ADJUST MANUAL TRANSAXLE OIL
8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

9. CHECK ABS SPEED SENSOR SIGNAL
(a) Anti-lock Brake System (Test Mode Procedure)

(b) Vehicle Stability Control System (Test Mode Procedure)