Installation

A245E AUTOMATIC TRANSAXLE: FLOOR SHIFT ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FLOOR SHIFT ASSEMBLY

(a) Install the floor shift assembly with the 4 bolts.
Torque: 12 Nm (122 kgf-cm, 9 ft-lbf)

HINT: Tighten them in the order, A, B, C and D.

(b) Connect the 2 wire harness clamps to the shift lever plate.
(c) Connect the 2 connectors.
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Install the control cable to the shift lever plate.

HINT: Fit the claws securely.

(b) Install the cable end to the rod of the floor shift assembly.

HINT: Install it with the uneven surface facing upward.

3. CONNECT FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY

(a) Set the accessory tool.
(1) Shift the shift lever to N position and turn the ignition switch to ACC or ON.
(2) Set the accessory tool to the shift lock control unit assembly as shown in the illustration.
Accessory tool parts No.:
33693-02010

HINT: Only in the case of reusing the shift lock control unit assembly.

(b) Using a screwdriver, unlock the claw of the lock key of automatic adjustment parts.

(d) Insert the lever pin into the hole in the cable end.

HINT: Fit the claws securely.

(e) Lock the lock key.

HINT: At this time, the shift lever should be in N position and the ignition key should be set to ACC or ON.

(f) Remove the accessory tool.
Accessory tool parts No.:
33693-02010
4. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY
5. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
6. INSTALL CONSOLE BOX CARPET
7. INSTALL UPPER CONSOLE PANEL
8. CHECK KEY INTERLOCK OPERATION (Testing and Inspection)

9. CHECK SHIFT LOCK OPERATION (Testing and Inspection)

10. CHECK SHIFT LOCK RELEASE BUTTON OPERATION (Testing and Inspection)