Disassembly
A245E AUTOMATIC TRANSAXLE: FLOOR SHIFT ASSEMBLY: DISASSEMBLY
DISASSEMBLY
1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Releasing the lock by pressing the slick, disconnect the indicator light wire connector from the shift lever plate.
(b) Disengage the secondary locking device.
(c) Using a small screwdriver, disengage the locking lug of the terminals 2 and 4, and pull the terminals out from the rear.
(d) Disconnect the wire harness from the clamps.
(e) Remove the 2 screws and shift lever knob sub-assembly.
NOTE: Pay attention not to apply unnatural load to transmission control switch wire harness.
2. REMOVE FLOOR SHIFT SHIFT LEVER KNOB COVER
(a) Remove the shift lever knob cover.
3. REMOVE TRANSMISSION CONTROL SWITCH
(a) Using a small screwdriver, remove the transmission control switch.
HINT: Tape up the screwdriver tip before use.
4. REMOVE SHIFT LEVER KNOB BUTTON
(a) Remove the shift lever knob button and spring.
5. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY
(a) Remove the indicator light wire sub-assembly.
(b) Remove the cap and bulb from the indicator light wire sub-assembly.
6. REMOVE SHIFT LOCK RELEASE BUTTON COVER
(a) Using a screwdriver, remove the shift lock release button cover.
HINT: Tape up the screwdriver tip before use.
7. REMOVE UPPER POSITION INDICATOR HOUSING
(a) Using a screwdriver, release the 4 claws and remove the upper position indicator housing.
HINT: Tape up the screwdriver tip before use.
8. REMOVE CONTROL POSITION INDICATOR PLATE
(a) Remove the position indicator plate from the upper position indicator housing.
9. REMOVE POSITION INDICATOR SLIDE COVER
(a) Remove the position indicator slide cover.
10. REMOVE LOWER POSITION INDICATOR HOUSING
(a) Using a screwdriver, release the 3 claws and remove the lower position indicator housing.
HINT: Tape up the screwdriver tip before use.
11. REMOVE SHIFT LOCK RELEASE BUTTON
(a) Remove the shift lock release button and spring.
12. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY
(a) Using a screwdriver, remove the toggle lever support pin and shift lock control unit assembly.
NOTE: Work so as not to damage the stopper position.
HINT: Tape up the screwdriver tip before use.
13. REMOVE NO.1 SHIFT LEVER INSERT