Installation

A245E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

INSTALLATION

1. INSTALL TRANSAXLE HOUSING OIL SEAL (for RH Side)





(a) Using SST and a hemmer, drive in a new oil seal.
SST: 09350-32014
09351-32130
09351-32150
Oil seal drive in depth:
1.5 to 2.5 mm (0.059 to 0.098 in.)
(b) Coat the lip of the oil seal with MP grease.
2. INSTALL TRANSAXLE CASE OIL SEAL (for LH Side)





(a) Using SST and a hammer, drive in a new oil seal.
SST: 09350-32014
09351-32111
09351-32130
Oil seal drive in depth:
4.8 to 5.8 mm (0.189 to 0.228 in.)
(b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (Installation)

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (Installation)

5. INSTALL ENGINE UNDER COVER LH
6. INSTALL ENGINE UNDER COVER RH
7. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
8. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:
T-IV
Capacity:
3.0 liters (3.2 US qts, 2.6 lmp.qts)
9. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT: (Procedures)

10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT: (Service and Repair)

11. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)

HINT:
- with VSC (Test Mode Procedure)
- without VSC (Test Mode Procedure)