Installation

A245E AUTOMATIC TRANSAXLE: FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY

(a) Turn the ignition switch ACC or ON.
(b) Install the cable to the upper bracket.

HINT: Connect the removed cable so that it will be the same physical relationship you kept in mind before its disconnection.

(d) Set the accessory tool.
(1) Shift the shift lever to N position and turn the ignition switch to ACC or ON.
(2) Set the accessory tool to the shift lock control unit assembly as shown in the illustration.
Accessory tool parts No.:
33693-02010

(e) Using a screwdriver, unlock the claw of the lock key of automatic adjustment part.

HINT: Tape up the screwdriver tip before use.

(f) Insert the slide cap into the through hole and install.

(g) Insert the lever pin into the hole in the cable end.

HINT: Fit the claws securely.

(h) Lock the lock key.

HINT: At this time, the shift lever should be in N position and the ignition key should be set to ACC or ON.

(i) Remove the accessory tool.
Accessory tool parts No.:
33693-02010
2. INSTALL STEERING WHEEL ASSEMBLY (Installation)

3. INSPECT STEERING WHEEL CENTER POINT

HINT: (Installation)

4. INSTALL STEERING PAD ASSEMBLY
5. INSPECT SRS WARNING LIGHT

HINT: (Check Mode Procedure)

6. CHECK KEY INTERLOCK OPERATION (Testing and Inspection)