Installation

EXTERIOR: REAR BUMPER: INSTALLATION

INSTALLATION

1. INSTALL REAR BUMPER ARM LH
(a) Install the rear bumper arm LH with the 3 bolts.
Torque: 36 Nm (367 kgf-cm, 27 ft-lbf)
2. INSTALL REAR BUMPER ARM RH
(a) Use the same procedures described for the LH side.
3. INSTALL REAR BUMPER REINFORCEMENT NO. 1
(a) Install the rear bumper reinforcement No. 1 with the 4 nuts.
Torque: 36 Nm (367 kgf-cm, 27 ft-lbf)
(b) Install the 2 rear bumper reinforcements No. 5 to the rear bumper reinforcement No. 1 with the 4 clips.
4. INSTALL BUMPER MOULDING SET BOLT NO. 1
5. INSTALL REAR NO. 2 SPOILER SUB-ASSEMBLY (w/ Rear Spoiler)
(a) Install the 5 retainers and a screw with the rear spoiler.
6. INSTALL REAR NO. 1 SPOILER SUB-ASSEMBLY (w/ Rear Spoiler)
(a) Use the same procedures described for the LH side.
7. INSTALL REAR BUMPER REINFORCEMENT NO. 2
(a) Install the bumper reinforcement to the rear bumper energy absorber.
8. INSTALL REAR BUMPER ENERGY ABSORBER
9. INSTALL REAR BUMPER COVER
(a) Install the bumper cover with the 2 screws, 8 clips and 4 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
10. CONNECT REAR BUMPER SIDE SEAL LH
11. CONNECT REAR BUMPER SIDE SEAL RH
12. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH
(a) Install the luggage compartment trim cover with the 4 clips.
13. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER RH
(a) Use the same procedures described for the LH side.
14. INSTALL REAR FLOOR FINISH PLATE
(a) Install the floor finish plate with the 3 clips.