Component Tests and General Diagnostics

TIRE AND WHEEL: TIRE AND WHEEL SYSTEM:

INSPECTION

1. INSPECT TIRE
(a) Check the tires for wear and proper inflation pressure.
Cold tire inflation pressure:





When driving under the above vehicle conditions at sustained high speeds above 160 km/h (100 mph), in countries where such speeds are permitted by law, inflate the front and rear tires to 240 kPa (2.4 kgf*cm2, 35 psi) provided that it does not exceed the maximum cold tire inflation pressure molded on the tire sidewall.






(b) Using a dial indicator, check the runout of the tires.
Tire runout:
1.4 mm (0.055 in.) or less






2. ROTATE TIRES
HINT: Rotate the tires as shown in illustration.

3. INSPECT WHEEL BALANCE
(a) Check and adjust the off-the-car balance.





(1) Steel wheel
Imbalance after adjustment:
8.0 g (0.018 lb.) or less.
HINT: If necessary, check and adjust the on-the-car balance.





(2) Others (Non-steel wheel)
Imbalance after adjustment:
8.0 g (0.018 lb.) or less.
- Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
- Do not touch the sticking surface of the tape.
- Adhere the sticking type balance weight to the flat position shown in the illustration.
- Push the balance weight securely with a finger to adhere it to the indicated position.
- Do not reuse balance weights.
- The inner side balance weight should be installed by clipping it to the rim.
- If necessary, check and adjust the on-the-car balance.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

5. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing

6. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

7. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub and Bearing