Removal

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR (for TMC Made):

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

5. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Removal

6. REMOVE FRONT DOOR SCUFF PLATE LH Removal

7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

8. REMOVE FRONT DOOR SCUFF PLATE RH Removal

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH Removal

11. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Removal

12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

13. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Removal

14. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

15. REMOVE CONSOLE BOX POCKET Removal

16. REMOVE CONSOLE BOX CARPET Removal

17. REMOVE CONSOLE BOX ASSEMBLY Removal

18. REMOVE NO. 2 CONSOLE BOX INSERT FRONT Removal

19. REMOVE NO. 1 CONSOLE BOX INSERT FRONT Removal

20. REMOVE NO. 1 CONSOLE BOX DUCT Removal

21. REMOVE YAW RATE AND ACCELERATION SENSOR






(a) Disconnect the yaw rate and acceleration sensor connector.
(b) Remove the 2 bolts and yaw rate and acceleration sensor.
NOTE: Do not remove the yaw rate and acceleration sensor from the bracket.