Removal

U660E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE COOL AIR INTAKE DUCT SEAL

3. REMOVE NO. 2 AIR CLEANER INLET

4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

5. REMOVE AIR CLEANER CASE

6. REMOVE NO. 1 AIR CLEANER INLET

7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY






(a) Remove the clip from the transmission cable bracket.






(b) Remove the nut, washer and control shaft lever with transmission control cable assembly from the control shaft.
8. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY






(a) Disconnect the connector from the park/neutral position switch.






(b) Remove the 2 bolts and park/neutral position switch from the control shaft.
NOTICE: Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.