Installation

AXLE: REAR AXLE HUB AND BEARING: INSTALLATION

INSTALLATION

1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH






(a) Install the hub & bearing assembly LH with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft-lbf)
2. CONNECT SKID CONTROL SENSOR
(a) Connect the skid control sensor connector.
NOTICE: Do not twist the sensor wire when connecting it.

3. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub and Bearing

4. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub and Bearing

5. INSTALL REAR DISC
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH






(a) Install the rear disc brake caliper assembly LH with the 2 bolts.
Torque: 62 Nm (632 kgf-cm, 46 ft-lbf)
NOTICE: Do not twist the brake hose when installing the rear disc brake caliper assembly LH.





(b) Install the rear flexible hose with the bolt.
Torque: 19 Nm (192 kgf-cm, 14 ft-lbf)
7. INSTALL REAR WHEEL
Torque: 103 Nm (1.050 kgf-cm, 76 ft-lbf)
8. ABS SPEED SENSOR SIGNAL
(a) ABS WITH EBD & TRAC & VSC SYSTEM Test Mode Procedure

(b) ABS WITH EBD SYSTEM Test Mode Procedure