Seals and Gaskets: Service and Repair
DIFFERENTIAL OIL SEALCOMPONENTS:
REMOVAL
1. DRAIN MANUAL TRANSAXLE OIL
2. REMOVE FRONT WHEELS
3. REMOVE ENGINE UNDER COVER LH
4. REMOVE ENGINE UNDER COVER RH
5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
7. REMOVE FRONT TRANSAXLE CASE OIL SEAL
(a) Using SST, remove the oil seal.
SST 09308-00010
8. REMOVE TRANSMISSION CASE OIL SEAL
(a) Using SST, remove the oil seal.
SST 09308-00010
INSTALLATION
1. INSTALL FRONT TRANSAXLE CASE OIL SEAL
(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST 09554-14010, 09950-70010 (09951-07200)
Drive in depth: 1.9 ± 0.3 mm (0.075 ± 0.012 in.)
NOTICE: Be careful not to damage the oil seal lip.
2. INSTALL TRANSMISSION CASE OIL SEAL
(a) Coat a new oil seal lip with MP grease.
(b) Using SST and a hammer, install the oil seal.
SST 09554-14010, 09950-70010 (09951-07200)
Drive in depth: 9.9 ± 0.3 mm (0.390 ± 0.012 in.)
NOTICE: Be careful not to damage the oil seal lip.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
5. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf/cm, 76 ft. lbs.)
6. ADD MANUAL TRANSAXLE OIL
(a) Add the manual transaxle oil.
Oil grade: API GL-4 or GL-5
Viscosity: SAE 75 W-90
Capacity: 1.9 liters (2.0 US qts, 1.7 Imp. qts)
Torque: 39.2 Nm (400 kgf/cm, 29 ft. lbs.)
7. INSPECT AND ADJUST MANUAL TRANSAXLE OIL
8. CHECK ABS SPEED SENSOR SIGNAL
(a) Anti-lock Brake System
(b) Vehicle Stability Control System