Ignition Switch: Service and Repair

Ignition Switch:

Ignition Switch

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL

2. REMOVE STEERING COLUMN COVER LWR
a. Remove the 3 screws, then remove the steering column cover LWR.

3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY
a. Disconnect the ignition switch connector and unlock warning switch connector.

b. Disconnect the unlock warning switch connector from the ignition switch assembly.

c. Disconnect the wire harness from the steering assembly.

d. Remove the 2 screws, then remove the ignition switch assembly.

INSTALLATION

1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
a. Install the ignition switch assembly with the 2 screws.

b. Connect the wire harness to the steering assembly.

c. Connect the unlock warning switch connector to the ignition switch assembly.

d. Connect the ignition switch connector and unlock warning switch connector.

2. INSTALL STEERING COLUMN COVER LWR
a. Install the steering column cover LWR with the 3 screws.

3. CONNECT BATTERY NEGATIVE TERMINAL

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)