Skid Control Sensor
REMOVALHINT: Replace the RH side by the same procedure as the LH side.
1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type)
4. REMOVE REAR DISC (for Disc Type)
5. DISCONNECT SKID CONTROL SENSOR WIRE
a. Disconnect the skid control sensor wire connector from the skid control sensor.
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
7. REMOVE SKID CONTROL SENSOR
a. Mount the rear axle hub in a soft jaw vise.
NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.
b. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020
NOTE:
- If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
- Do not scratch the contacting surface of axle hub and speed sensor.
INSTALLATION
1. INSTALL SKID CONTROL SENSOR
a. Clean the contacting surface of the axle hub and a new speed sensor.
NOTE: Do not stick any foreign objects to the sensor rotor.
b. Place the speed sensor on the axle hub so that the connector makes the lowest position under the on-vehicle condition.
c. Using SST and press, install the new speed sensor to axle hub.
SST 09214-76011
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
3. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the skid control sensor wire connector to the skid control sensor.
4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Drum Type)
5. INSTALL REAR DISC (for Disc Type)
6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (for Disc Type)
7. INSTALL REAR WHEEL
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
9. CHECK ABS SPEED SENSOR SIGNAL