Seat Belt Systems: Service and Repair

Front Seat Inner Belt Assembly:

Front Seat Inner Belt Assembly

REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE: Wait for 90 seconds after disconnecting the cable to prevent the airbag from deploying.

2. REMOVE SEAT TRACK BRACKET COVER OUTER RH
3. REMOVE SEAT TRACK BRACKET COVER INNER RH
4. REMOVE FRONT SEAT TRACK COVER RH REAR OUTER
5. REMOVE FRONT SEAT TRACK COVER RH REAR INNER
6. REMOVE FRONT SEAT HEADREST ASSEMBLY
7. REMOVE FRONT SEAT ASSEMBLY RH
8. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH

INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the RH side.

1. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH
a. Connect the connector and engage the clamps.
b. Engage the wire harness of the inner belt to the cushion shield inner RH.
c. Install the cushion shield inner RH (with wire harness) with the screw.
d. Install the belt with the bolt.

Torque: 41 N.m (418 kgf.cm, 30 ft.lbf)

2. INSTALL FRONT SEAT ASSEMBLY RH
3. INSTALL FRONT SEAT TRACK COVER RH REAR INNER
4. INSTALL SEAT TRACK COVER RH REAR OUTER
5. INSTALL SEAT TRACK BRACKET COVER OUTER RH
6. INSTALL SEAT TRACK BRACKET COVER INNER RH
7. CHECK SEAT SLIDE ADJUSTER LOCKS
8. CONNECT BATTERY NEGATIVE TERMINAL
9. INSPECT SRS WARNING LIGHT