Front Seat Assembly (for LH Side)
FRONT SEAT ASSEMBLY (for LH Side)Front Seat Assembly (for LH Side):
REMOVAL
HINT: A bolt without a torque specification is shown in the standard bolt chart.
NOTICE: Wear protective gloves. Sharp areas on the seat adjuster can cause injuries to your hands.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE: Work must be started at least 90 seconds after the ignition switch is turned OFF and the negative (-) terminal cable is disconnected from the battery.(The SRS is equipped with a back-up power source. If work is started within 90 seconds after turning the ignition switch OFF and disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)
2. REMOVE FRONT SEAT TRACK BRACKET COVER OUTER LH
3. REMOVE FRONT SEAT TRACK BRACKET COVER INNER LH
4. REMOVE FRONT SEAT TRACK COVER LH REAR OUTER
a. Move the front seat assembly fully forward by operating the slide handle.
b. Using a screwdriver, disengage the 4 claws and remove the cover.
HINT: Tape the screwdriver tip before use.
5. REMOVE FRONT SEAT TRACK COVER LH REAR INNER
a. Using a screwdriver, disengage the 2 claws and remove the cover.
HINT: Tape the screwdriver tip before use.
6. REMOVE FRONT SEAT HEADREST ASSEMBLY
7. REMOVE FRONT SEAT ASSEMBLY LH
a. Lift up the seat track adjusting handle and move the seat to the rearmost position.
b. Remove the 2 bolts on the front side of the seat.
c. Lift up the seat track adjusting handle and move the seat to the front most position.
d. Remove the 2 bolts on the rear side of the seat.
e. Disconnect the connectors under the seat. Then remove the front seat.
NOTICE: Be careful not to damage the vehicle body.
INSTALLATION
1. INSTALL FRONT SEAT ASSEMBLY LH
a. Place the seat in the cabin.
NOTICE: Be careful not to damage the vehicle body.
b. Connect the connectors under the seat.
c. Tighten the 4 bolts in the order indicated in the illustration.
Torque: 37 N.m (377 kgf.cm, 27 ft.lbf)
2. INSTALL FRONT SEAT HEADREST ASSEMBLY
3. INSTALL FRONT SEAT TRACK COVER LH REAR INNER
4. INSTALL FRONT SEAT TRACK COVER LH REAR OUTER
5. REMOVE FRONT SEAT TRACK BRACKET COVER INNER LH
6. REMOVE FRONT SEAT TRACK BRACKET COVER OUTER LH
7. CHECK SEAT SLIDE ADJUSTER LOCKS
a. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
If the adjusters do not lock simultaneously, loosen the seat fixation bolts to adjust the adjuster's positions.
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. CHECK SRS WARNING LIGHT