Shift Cable: Service and Repair

TRANSMISSION CONTROL CABLE ASSEMBLY

COMPONENTS:

REMOVAL
1. PRECAUTION
2. SEPARATE BATTERY NEGATIVE TERMINAL
3. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
4. REMOVE UPPER CONSOLE PANEL
5. REMOVE CONSOLE BOX CARPET
6. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
7. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
8. SEPARATE OXYGEN SENSOR CONNECTOR
(a) Remove the foot rest.
(b) Pull up the floor carpet.
(c) Disconnect the oxygen sensor connector.
9. REMOVE FLOOR PANEL BRACE FRONT
(a) Remove the 2 nuts and floor panel brace.
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
11. REMOVE NO.1 FRONT FLOOR HEAT INSULATOR
(a) Remove the 3 nuts and heat insulator.
12. REMOVE AIR CLEANER ASSEMBLY WITH HOSE
13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the nut and disconnect control cable from control shaft lever.





(b) Remove the clip and disconnect the control cable from the bracket.





(c) Disconnect the control cable from control cable support.





(d) Remove the 2 nuts and separate the control cable from the body.





(e) Remove the cable end from the floor shift assembly.





(f) Using a screwdriver, disconnect the control cable from the shift lever plate.

HINT: Tape up the screwdriver tip before use.





(g) Remove the 2 bolts.
(h) Pull out the control cable assembly from the body.
(i) Remove the retainer from the shift cable.

INSTALLATION
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Install the retainer to the shift cable.
(b) Pull in the control cable assembly to the body.





(c) Install the 2 bolts.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)





(d) Install the control cable to the shift lever plate.





(e) Connect the control cable end to the floor shift assembly.

HINT: Install it with the uneven surface facing up.





(f) Install the control cable with the 2 nuts to the body.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)





(g) Connect the control cable to the control cable support.
(h) Temporarily install the control cable to the control shaft lever with nut.





(i) Install the control cable with the clip to the bracket.

NOTICE: Insert the cable securely.

2. INSTALL AIR CLEANER ASSEMBLY WITH HOSE
Torque: 7.0 Nm (71 kgf-cm, 62 inch lbs.)
3. INSTALL NO.1 FRONT FLOOR HEAT INSULATOR
(a) Install the heat insulator with the 3 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
4. INSTALL FRONT EXHAUST PIPE ASSEMBLY
5. INSTALL FRONT FLOOR PANEL BRACE
(a) Install the floor panel brace with the 2 nuts.
Torque: 30 Nm (306 kgf-cm, 22 ft. lbs.)
6. INSTALL OXYGEN SENSOR CONNECTOR
(a) Connect the oxygen sensor connector.
(b) Install the floor carpet and foot rest.
7. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
SST 09249-63010
8. ADJUST SHIFT LEVER POSITION
9. INSPECT SHIFT LEVER POSITION
10. INSPECT SRS WARNING LIGHT