Parking Lock Cable: Service and Repair

FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY

COMPONENTS:

REMOVAL
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING PAD ASSEMBLY
5. REMOVE STEERING WHEEL ASSEMBLY
6. REMOVE STEERING COLUMN COVER
7. REMOVE UPPER CONSOLE PANEL
8. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
9. REMOVE CONSOLE BOX CARPET
10. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY





11. REMOVE FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY
(a) Remove the cable end from the lever pin of the floor shift assembly.





(b) Using a screwdriver, disconnect the parking lock cable from the floor shift assembly.

HINT: Tape up the screwdriver tip before use.





(c) Disconnect the cable clamp.
(d) Turn the ignition switch ACC or ON.





(e) Using a screwdriver, remove the cable from the upper bracket.

HINT:
^ Before disconnecting the cable, keep in mind each of the physical relationship between the connector and wire harness or other cables.
^ Tape up the screwdriver tip before use.

INSTALLATION





1. INSTALL FLOOR SHIFT PARKING LOCK CABLE ASSEMBLY
(a) Turn the ignition switch ACC or ON.
(b) Install the cable to the upper bracket.

HINT: Connect the removed cable so that it will be the same physical relationship you kept in mind before its disconnection.





(c) Connect the cable clamp.





(d) Set the accessory tool.
(1) Shift the shift lever to N position and turn the ignition switch to ACC or ON.
(2) Set the accessory tool to the shift lock control unit assembly as shown in the illustration.
Accessory tool parts No.: 33693-02010





(e) Using a screwdriver, unlock the claw of the lock key of automatic adjustment part.

HINT: Tape up the screwdriver tip before use.





(f) Insert the slide cap into the through hole and install.





(g) Insert the lever pin into the hole in the cable end.

HINT: Fit the claws securely.





(h) Lock the lock key.

HINT: At this time, the shift lever should be in N position and the ignition key should be set to ACC or ON.

(i) Remove the accessory tool.
Accessory tool parts No.: 33693-02010
2. INSTALL STEERING WHEEL ASSEMBLY
3. INSPECT STEERING WHEEL CENTER POINT
4. INSTALL STEERING PAD ASSEMBLY
5. INSPECT SRS WARNING LIGHT
6. CHECK KEY INTERLOCK OPERATION