Front Passenger Airbag Assembly

Front Passenger Airbag Assembly:

FRONT PASSENGER AIRBAG ASSEMBLY

REMOVAL

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (Refer to Restraint Systems Service Precautions).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY




a. Remove the screw from the glove compartment door stopper sub-assembly.
b. Pull the glove compartment door assembly to remove it.

4. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR




a. Disconnect the connector from the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

5. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY




a. Remove the bolt and the 2 nuts.
b. Remove the front passenger airbag assembly.

INSTALLATION

1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY




a. Install the front passenger airbag assembly with the bolt and the 2 nuts.

Torque:
Bolt 20 N.m (204 kgf.cm, 15 ft.lbf)

2. CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR




a. Connect the connector to the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION
a. Perform initialization.

HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.

6. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.