From 03-2006 to 10-2006

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: REMOVAL

REMOVAL

HINT:
- Use the same procedure for the RH side and the LH side.
- The procedure listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing Vehicle Damage Warnings.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

3. REMOVE FRONT DOOR SCUFF PLATE Removal
4. REMOVE REAR DOOR SCUFF PLATE Removal
5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
7. REMOVE LOWER CENTER PILLAR GARNISH Removal
8. REMOVE SIDE AIRBAG SENSOR





(a) Remove the bolt and side airbag sensor from the body.
(b) Disconnect the connector from the side airbag sensor.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.