From 03-2006 to 10-2006

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY





(a) Connect the connector to the tire pressure warning receiver assembly.
(b) Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66in-lbf)
2. INSTALL INNER ROOF SIDE GARNISH LH Installation
3. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH Installation
4. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION

NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

7. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT: Test Mode Procedure