Terminals of ECU

TERMINALS OF ECU

NOTE:
- Turn the power switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
- After the power switch is turned off, check that the key reminder warning system and lighting system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

1. JUNCTION CONNECTOR (NO. 1 CAN J/C, NO. 2 CAN J/C)

Terminals Of Control Module/Pinouts (Part 1):

Terminals Of Control Module/Pinouts (Part 2):

a. No. 1 CAN J/C

Terminals Of Control Module/Pinouts:

b. No. 2 CAN J/C (FRONT OF THE VEHICLE)

Terminals Of Control Module/Pinouts:

c. No. 2 CAN J/C (REAR OF THE VEHICLE)

Terminals Of Control Module/Pinouts (Part 1):

Terminals Of Control Module/Pinouts (Part 2):

d. No. 3 CAN J/C (FRONT OF THE VEHICLE)

Terminals Of Control Module/Pinouts:

e. No. 3 CAN J/C (REAR OF THE VEHICLE)

Terminals Of Control Module/Pinouts:

f. The connection diagram of the components which are connected to the CAN J/C

Terminals Of Control Module/Pinouts (Part 1):

2. DLC3

Terminals Of Control Module/Pinouts (Part 2):

a. Measure the resistance according to the value(s) in the table.

3. SKID CONTROL ECU

Terminals Of Control Module/Pinouts (Part 1):

a. Disconnect the connectors from the skid control ECU.

Terminals Of Control Module/Pinouts (Part 4):

b. Measure the resistance according to the value(s) in the table.

4. STEERING ANGLE SENSOR

Terminals Of Control Module/Pinouts (Part 1):

a. Disconnect the E17 connector from the steering angle sensor.

Terminals Of Control Module/Pinouts (Part 2):

b. Measure the resistance according to the value(s) in the table.

5. YAW RATE SENSOR

Terminals Of Control Module/Pinouts (Part 1):

Terminals Of Control Module/Pinouts (Part 2):

a. Measure the resistance according to the value(s) in the table.

6. CENTER AIRBAG SENSOR ASSEMBLY

Terminals Of Control Module/Pinouts (Part 1):

a. Disconnect the E30 connector from the center airbag sensor assembly.

Terminals Of Control Module/Pinouts (Part 2):

b. Measure the resistance according to the value(s) in the table.

7. HV CONTROL ECU

Terminals Of Control Module/Pinouts (Part 1):

a. Disconnect the A61 connector from the HV control ECU.

Terminals Of Control Module/Pinouts (Part 2):

1. Measure the resistance according to the value(s) in the table.

Terminals Of Control Module/Pinouts (Part 3):

b. Measure the resistance according to the value(s) in the table.

8. AIR CONDITIONING AMPLIFIER
a. Check harness side connector E38 of the air conditioning amplifier.