From 03-2006 to 10-2006

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR

1. DTC CHECK (USING SST CHECK WIRE)





(a) Check for DTCs.
(1) Using SST, connect terminals TC and CG of DLC3.
SST: 09843-18040
(2) Turn the power switch on (IG).
(3) Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration on the left for examples of a normal system code and codes 13 and 33.

HINT:
- If the tire pressure warning light does not indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC and CG terminal circuit.





- If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
(4) Refer to the Diagnostic Trouble Code Chart Tire Pressure Warning System for DTC information.
(5) After completing the check, turn the power switch off and remove the SST from DLC3.
SST: 09843-18040

2. DTC CHECK (USING INTELLIGENT TESTER)





(a) Check for DTCs.
(1) Connect the intelligent tester to the DLC3.
(2) Turn the power switch on (IG).
(3) Read the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.

(b) Clear the DTCs.

HINT: After repairing the malfunctions, clear the DTCs.

(1) Connect the intelligent tester to DLC3.
(2) Turn the power switch on (IG).
(3) Clear the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.