From 10-2006

TIRE AND WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

INSPECTION

1. INSPECT TIRE
(a) Check the tires for wear and proper inflation pressure.
Cold tire inflation pressure:





When driving under the above vehicle conditions at sustained high speeds above 160 km/h (100 mph), in countries where such speeds are permitted by law, inflate the front and rear tires to 240 kPa (2.4 kgf*cm2, 35 psi) provided that it does not exceed the maximum cold tire inflation pressure molded on the tire sidewall.





(b) Using a dial indicator, check the runout of the tires.
Tire runout:
1.4 mm (0.055 in.) or less





2. ROTATE TIRES

HINT: Rotate the tires as shown in illustration.

3. INSPECT WHEEL BALANCE





(a) Check and adjust the off-the-car balance.
Imbalance after adjustment:
8.0 g (0.018 lb.) or less.

NOTICE:
- Remove dirt, oil, and water from the surface where the balance weight is to be adhered with a cleaning detergent.
- Do not touch the sticking surface of the tape.
- Adhere the sticking type balance weight to the flat position shown in the illustration.
- Push the balance weight securely with a finger to adhere it to the indicated position.
- Do not reuse balance weights.
- The inner side balance weight should be installed by clipping it to the rim.
- If necessary, check and adjust the on-the-car balance.

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

HINT: Front Axle Hub

5. INSPECT REAR AXLE HUB BEARING LOOSENESS

HINT: Rear Axle Hub and Bearing

6. INSPECT FRONT AXLE HUB RUNOUT

HINT: Front Axle Hub

7. INSPECT REAR AXLE HUB RUNOUT

HINT: Rear Axle Hub and Bearing