Part 2

2AZ-FXE ENGINE MECHANICAL: ENGINE UNIT: REASSEMBLY

REASSEMBLY

Part 2

50. INSTALL CAMSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring of the sensor.





(b) Install the sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
51. INSTALL CYLINDER HEAD COVER GASKET





(a) Install the gasket to the cylinder head cover.

NOTICE: Remove any oil from the contact surface.

52. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY Installation
53. INSTALL OIL FILTER UNION





(a) Using a 12 mm hexagon wrench, install the oil filter union.
Torque: 30 Nm (306 kgf-cm, 22ft-lbf)
54. INSTALL OIL FILTER SUB-ASSEMBLY
(a) Check and clean the oil filter installation surface.
(b) Apply clean engine oil to the gasket of a new oil filter.
(c) Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.
(d) When using a torque wrench:





(1) Using SST, tighten the oil filter.
SST: 09228-06501
Torque: 13 Nm (133 kgf-cm, 10ft-lbf)
(e) When not using a torque wrench:





(1) Using SST, tighten it an additional 3/4 turn.
SST: 09228-06501
55. INSTALL SPARK PLUG





(a) Install the spark plugs.
Torque: 19 Nm (194 kgf-cm, 14ft-lbf)
56. INSTALL VENTILATION VALVE SUB-ASSEMBLY





(a) Apply adhesive to the threads of the ventilation valve.





(b) Install the ventilation valve.
Torque: 19 Nm (194 kgf-cm, 14ft-lbf)
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
57. INSTALL OIL FILLER CAP GASKET





(a) Install a new gasket to the cap.
58. INSTALL OIL FILLER CAP SUB-ASSEMBLY





(a) Install the oil filler cap.