From 10-2006

BRAKE: REAR BRAKE: INSTALLATION

INSTALLATION

1. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY





(a) Install the rear disc brake cylinder assembly with the 2 bolts.
Torque: 27 Nm (275 kgf-cm, 20ft-lbf)

NOTICE: Install the rear disc brake bushing dust boot onto the groove of the rear disc brake cylinder.





(b) Connect the rear brake flexible hose with the union bolt and a new gasket.
Torque: 33 Nm (337 kgf-cm, 24ft-lbf)
2. ADD BRAKE FLUID TO RESERVOIR Brake Fluid
3. INSTALL ABS MOTOR RELAY
(a) Install the 2 ABS motor relays with the power switch off.
4. BLEED REAR BRAKE SYSTEM Brake Fluid
5. CLEAR DTC FOR BRAKE CONTROL SYSTEM

HINT: Refer the procedures up to "ELECTRONICALLY CONTROLLED BRAKE SYSTEM". DTC Check / Clear

6. PERFORM ACCUMULATOR PRESSURE ZERO DOWN Brake Fluid
7. CHECK BRAKE FLUID LEVEL IN RESERVOIR Brake Fluid
8. CHECK FOR BRAKE FLUID LEAKAGE
9. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)