Rear Door Lock

Rear Door Lock:

REAR DOOR LOCK

REMOVAL

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
2. REMOVE DOOR ASSIST GRIP COVER
3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
6. REMOVE REAR DOOR SERVICE HOLE COVER

7. REMOVE REAR DOOR LOCK ASSEMBLY




a. Using a "torx" socket wrench (T30), remove the 3 screws.
b. Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.
c. Remove the door lock wiring harness seal from the rear door lock assembly.




d. Using a screwdriver, disengage the claw.

HINT: Tape the screwdriver tip before use.




e. Remove the rear door inside locking cable assembly.




f. Using a screwdriver, disengage the 3 claws.

HINT: Tape the screwdriver tip before use.




g. Remove the rear door inside locking cable assembly.

INSTALLATION

1. INSTALL REAR DOOR LOCK ASSEMBLY

NOTE:
- When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the door lock with a new one.
- Do not allow grease or dust to adhere to the surface of the door lock where the seal attaches.
- Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water intrusion to the connection, and result in a malfunction in the rear door lock assembly.




a. Install the rear door inside locking cable assembly.




b. Engage the 3 claws.




c. Install the rear door lock remote control cable assembly.




d. Engage the claw.
e. Apply MP grease to the sliding parts on the rear door lock assembly.
f. Install a new door lock wiring harness seal to the rear door lock assembly.




g. Insert the rear door lock assembly to the rear door outside handle release plate, and set the assembly to the rear door panel.
h. Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.

i. Using a "torx" socket wrench (T30), install the rear door lock assembly with the 3 screws.

Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)

j. Connect the connector.

2. INSTALL REAR DOOR SERVICE HOLE COVER
3. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
4. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
6. INSTALL DOOR ASSIST GRIP COVER
7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG