Shifter M/T: Service and Repair
FLOOR SHIFT LEVER ASSEMBLYCOMPONENTS:
REMOVAL
1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
3. REMOVE SHIFT LEVER KNOB SUBASSEMBLY
4. REMOVE UPPER CONSOLE PANEL
5. REMOVE UPPER CONSOLE REAR PANEL SUBASSEMBLY
6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the 2 clips and disconnect the end of the transmission control cable.
(b) Pull out the control cable assembly locks.
(c) Turn the adjust nut 180° clockwise. While holding the adjust nut, separate the control cable assembly.
7. REMOVE FLOOR SHIFT LEVER ASSEMBLY
(a) Remove the 4 bolts and shift lever assembly.
INSTALLATION
1. INSTALL FLOOR SHIFT LEVER ASSEMBLY
(a) Install the shift lever assembly with the 4 bolts.
Torque: 12 Nm (122 kgf-cm, 9 ft. lbs.)
2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the control cable to the shift lever retainer.
NOTICE:
^ The projecting part of the cable outer should face upward when the shift cable is connected.
^ After installation, make sure that the cable outer lock is projecting from A as shown in the illustration.
(b) Connect the end of the shift cable to the shift lever assembly with the clip.
(c) Connect the end of the select cable to the shift lever assembly with a new clip.
NOTICE:
^ The serrated part of the select cable point should face upward when the select cable point is connected.
^ The clip should be installed in the direction as shown in the illustration.
3. INSTALL UPPER CONSOLE REAR PANEL SUBASSEMBLY
4. INSTALL UPPER CONSOLE PANEL
5. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
6. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
7. INSTALL SHIFT LEVER KNOB SUBASSEMBLY