Transmission Speed Sensor: Service and Repair
SPEED SENSORCOMPONENTS:
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE BATTERY
3. REMOVE AIR CLEANER INLET ASSEMBLY
4. REMOVE AIR CLEANER CAP SUBASSEMBLY
5. REMOVE AIR CLEANER CASE SUBASSEMBLY
6. REMOVE SPEED SENSOR (NT SENSOR)
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.
7. REMOVE SPEED SENSOR (NC SENSOR)
(a) Disconnect the speed sensor connector.
(b) Remove the bolt and speed sensor.
(c) Remove the O-ring from the speed sensor.
INSPECTION
Sensor Side:
1. INSPECT SPEED SENSOR (NT SENSOR)
(a) Disconnect the speed sensor connector from the transaxle.
(b) Measure the resistance according to the values(s) in the table below.
Standard resistance:
If the resistance value is not as specified, replace the speed sensor.
Sensor Side:
2. INSPECT SPEED SENSOR (NC SENSOR)
(a) Disconnect the speed sensor connector from the transaxle.
(b) Measure the resistance according to the values(s) in the table below.
Standard Resistance:
If the resistance value is not as specified, replace the speed sensor.
INSTALLATION
1. INSTALL SPEED SENSOR (NC SENSOR)
(a) Coat a new O-ring with ATF WS and install it to the speed sensor.
(b) Install the speed sensor with the bolt.
Torque: 8.8 Nm (90 kgf-cm, 78 inch lbs.)
(c) Connect the speed sensor connector.
2. INSTALL SPEED SENSOR (NT SENSOR)
(a) Coat a new O-ring with ATF WS and install it to the speed sensor.
(b) Install the speed sensor with the bolt.
Torque: 8.8 Nm (90 kgf-cm, 78 inch lbs.)
(c) Connect the speed sensor connector.
3. INSTALL AIR CLEANER CASE SUBASSEMBLY
4. INSTALL AIR CLEANER CAP SUBASSEMBLY
5. INSTALL AIR CLEANER INLET ASSEMBLY
6. INSTALL BATTERY
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)