Brake Light Switch: Service and Repair
STOP LIGHT SWITCHCOMPONENTS:
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY
3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH
4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System)
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System)
7. REMOVE INSTRUMENT CLUSTER FINISH PANEL
8. REMOVE COMBINATION METER
9. REMOVE STOP LIGHT SWITCH
(a) Disconnect the stop light switch assembly connector from the stop light switch assembly.
(b) Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.
INSTALLATION
1. INSTALL STOP LIGHT SWITCH
(a) Insert the stop light switch assembly until the body hits the cushion.
NOTICE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
(b) Make a quarter turn clockwise to install the stop light switch assembly.
Torque: 1.5 Nm (15 kgf-cm, 13 inch lbs.) or less
NOTICE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
(c) Connect the stop light switch connector to the stop light switch assembly.
(d) Check the protrusion of the rod.
2. INSTALL COMBINATION METER
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL
4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System)
5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System)
6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH
8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY
9. INSTALL FRONT DOOR SCUFF PLATE