Fuel Gauge Sender: Service and Repair

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

3. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type).
4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)
6. REMOVE REAR FLOOR SERVICE HOLE COVER
7. SEPARATE FUEL PUMP TUBE SUB-ASSEMBLY
7. REMOVE FUEL TANK VENT TUBE SET PLATE
9. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
10. REMOVE FUEL SENDER GAUGE ASSEMBLY

INSTALLATION

1. INSTALL FUEL SENDER GAUGE ASSEMBLY
2. INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
3. INSTALL FUEL TANK VENT TUBE SET PLATE
4. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. CHECK FOR FUEL LEAKS
7. INSTALL REAR FLOOR SERVICE HOLE COVER
8. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
9. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)