Crankshaft Position Sensor: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT WHEEL RH
3. REMOVE FRONT FENDER APRON RH
4. REMOVE V-RIBBED BELT
5. REMOVE GENERATOR ASSEMBLY
6. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the connector clamp and wire harness clamp.
c. Remove the wire harness clamp bracket from the wire harness.
d. Remove the bolt, and then remove the crankshaft position sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
b. Install the crankshaft position sensor with the bolt.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
c. Connect the crankshaft position sensor connector.
2. INSTALL GENERATOR ASSEMBLY
3. INSTALL V-RIBBED BELT
4. INSTALL FRONT FENDER APRON SEAL RH
5. INSTALL FRONT WHEEL RH
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL