Pinout Values and Diagnostic Parameters
TERMINALS OF ECUNOTE: This section describes the standard CAN values for all CAN related components.
1. JUNCTION CONNECTOR (NO. 1 CAN J/C, NO. 2 CAN J/C)
a. No. 1 CAN J/C
b. No. 2 CAN J/C (FRONT OF THE VEHICLE)
c. No. 2 CAN J/C (REAR OF THE VEHICLE)
d. The connection diagram of the components which are connected to the CAN J/C
2. DLC3
a. Measure the resistance according to the value(s) in the table.
3. SKID CONTROL ECU (w/o VSC)
a. Disconnect the A25 connector from the skid control ECU.
b. Measure the resistance according to the value(s) in the table.
4. SKID CONTROL ECU WITH ACTUATOR (w/ VSC)
a. TMC made
1. Disconnect A26 connector from the skid control ECU.
2. Measure the resistance according to the value(s) in the table.
b. TMMK made
1. Disconnect the A60 connector from the skid control ECU.
2. Measure the resistance according to the value(s) in the table.
5. STEERING ANGLE SENSOR (W/ VSC)
a. Disconnect the E17 connector from the steering angle sensor.
b. Measure the resistance according to the value(s) in the table.
6. YAW RATE SENSOR (W/ VSC)
a. TMC made
1. Disconnect the E34 connector from the yaw rate sensor.
2. Measure the resistance according to the value(s) in the table.
b. TMMK made
1. Disconnect the E34 connector from the yaw rate sensor.
2. Measure the resistance according to the value(s) in the table.
7. CENTER AIRBAG SENSOR ASSEMBLY
a. Disconnect the E30 connector from the center airbag sensor assembly.
b. Measure the resistance according to the value(s) in the table.
8. ECM
a. AZ-FE
1. Disconnect the A24 connector from the ECM.
2. Measure the resistance according to the value(s) in the table.
3. Measure the resistance according to the value(s) in the table.
b. 2GR-FE
1. Disconnect the A55 connector from the ECM.
2. Measure the resistance according to the value(s) in the table.
3. Measure the resistance according to the value(s) in the table.
9. AIR CONDITIONING AMPLIFIER
a. Check the harness side connector (E38) of the air conditioning amplifier.
1. Disconnect the connector (E38) from the air conditioning amplifier.
2. Measure the resistance according to the value(s) in the table.
10. COMBINATION METER ECU
a. Disconnect the F1 connector from the combination meter.
b. Measure the resistance according to the value(s) in the table.
c. Measure the resistance according to the value(s) in the table.
11. CERTIFICATION ECU (W/ SMART KEY SYSTEM)
a. Disconnect the E58 connector from the certification ECU.
b. Measure the resistance according to the value(s) in the table.
12. MAIN BODY ECU (INSTRUMENT PANEL J/B)
a. Disconnect the E8 connector from the main body ECU.
b. Measure the resistance according to the value(s) in the table.
13. ACCESSORY GATEWAY
a. Measure the resistance according to the value(s) in the table.