Without Scan Tool

DTC CHECK (WHEN USING SST CHECK WIRE:)

DTC Check




1. Using SST, connect terminals TC and CG of the DLC3.

SST 09843-18040

2. Turn the ignition switch on (IG).
3. Observe the blinking pattern of the ABS and VSC (without multi-information display) warning lights or read the multi information display (with multi-information display) in order to identify the DTC.

HINT: If no code appears, inspect the TC and CG terminal circuit, the ABS warning light circuit, and the VSC warning light circuit.

Trouble Area
ABS warning light (Remains on)
ABS warning light (Does not come on)
VSC warning light (Remains on)
VSC warning light (Does not come on)
TC and CG Terminal Circuit




- As an example, the blinking patterns for a normal system code and trouble codes 11 and 21 are shown in the illustration.

4. Codes are explained in the code table.
5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK

a. Turn the ignition switch on (IG).
b. Check that the ABS warning light goes off within approximately 3 seconds.